Visitors Now:
Total Visits:
Total Stories:
Profile image
By RobertSiciliano
Contributor profile | More stories
Story Views

Now:
Last Hour:
Last 24 Hours:
Total:

Step by step how to reinforce Door Locks

Saturday, October 1, 2016 7:08
% of readers think this story is Fact. Add your two cents.

(Before It's News)

Don’t let the idea of reinforcing your house’s doors intimidate you. Here is step by step instruction on installing new stronger locks.

Your House’s Door Parts Inventory

  • Any door without a deadbolt gets a deadbolt, which should be a grade 1 or 2.
  • Are the screws of any existing deadbolts tight?
  • If you open the door and turn the knob, the deadbolt’s throw-bolt will pop out the side of the door. It should be at least one inch and appear secure.
  • The screws in the strike plates and deadbolts should be at least three inches.

Deadbolt Replacement

  • Chances are, your inferior deadbolt is held by four screws total.
  • Take the measurement of the distance between the center of the cylinder hole and the edge of the door. Write these down; you’ll need them for your new deadbolt.
  • Notate the horizontal and vertical center of the new hole.
  • Now drill, and slowly. Then test out the deadbolt. You may have to make refinements to the hole if the deadbolt doesn’t fit perfectly.
  • Before attaching the deadbolt, see if the attached throw-bolt strike plate has a flush fit.
  • Do not use a power drill to put in the screws, as this could strip the wood.

Lockset Strike Plate Replacement

  • Your new strike plate should be attached with three inch screws.
  • If the hole, through which you’re driving the screws, is too small, you’ll need to drill it out for a good fit.
  • The screws should be slightly angled to catch the framing.

Deadbolt Strike Plate Replacement

  • Your new deadbolt, upon purchase, will come with a strike plate. A very sturdy strike plate requires four screws.
  • Mark the old deadbolt strike plate’s center.
  • The new faceplate will be temporarily put in so that you can mark its position.
  • After taking out the plate, make sure that the holes through which you’ll be drilling screws will fit the screws. You may need to make adjustments to enlarge the holes.
  • Using a wood chisel, remove the wood so that the faceplate and strike box fit.
  • You’re now ready to mount the plate and box, using four screws of three inch length.

Installing strong locks is just one step in the process. However, I must say this: Kicking in a typical house door is a lot easier than reinforcing your door to make it kick-in-proof. A burglar needn’t be a karate expert or soccer player to kick open a locked door that’s inadequately secured. Watch this video “Anti-Kick door reinforcement” on how to secure your doors with door jam reinforcement technology.

Robert Siciliano is a home and personal security expert to DoorDevil.com. Disclosures.

Report abuse

Comments

Your Comments
Question   Razz  Sad   Evil  Exclaim  Smile  Redface  Biggrin  Surprised  Eek   Confused   Cool  LOL   Mad   Twisted  Rolleyes   Wink  Idea  Arrow  Neutral  Cry   Mr. Green

Top Stories
Recent Stories

Register

Newsletter

Email this story
Email this story

If you really want to ban this commenter, please write down the reason:

If you really want to disable all recommended stories, click on OK button. After that, you will be redirect to your options page.