Online:
Visits:
Stories:
Profile image
By AmmoLand (Reporter)
Contributor profile | More stories
Story Views

Now:
Last Hour:
Last 24 Hours:
Total:

The U.S. Krag-Jorgensen Rifle

Tuesday, February 21, 2017 6:27
% of readers think this story is Fact. Add your two cents.

(Before It's News)

By David Tong,
In this review, David Tong discusses the history behind the U.S. Krag-Jorgensen Rifle.

US Krag-Jorgensen Rifle and Cavalry CarbineUS Krag-Jorgensen Rifle and Cavalry Carbine

U.S.A.-(Ammoland.com)- As all the world’s militaries did by the late 1880s, the adoption of the repeating bolt action rifle with smokeless powder cartridges of approximately 0.30” caliber completely replaced the prior 0.45” caliber single-shot rifles of the 1870s.

In those days, it was a heady time for firearm designers. Most all designs were non-detachable box magazine types save the British Lee-Enfield, and these magazines were also generally machined steel items attached to the action by the combination trigger guard/floorplate of the German Mauser pattern.

One unique action that did not follow this pattern was the Norwegian Krag-Jorgensen. Named after its two designers Ole Krag and Erik Jorgensen around 1886, it featured an integral magazine that held the rounds in a semi-circle below the action in a rotary motion for feeding.

The original design was adopted by both Norway and Denmark in the 1890s and it soon caught the attention of US Army Ordnance and it was adopted by our government in 1892. It differed mostly from the original Norwegian design by a change to the magazine feed door. On the original Norwegian rifle, the door was hinged on its forward edge and operated exactly as a door on an automobile, while on the US Krag, the door was hinged on its bottom, and this may have provided somewhat less chance for dirt ingress during reloading in combat.

Krag-Jorgensen rifle's magazine feed doorKrag-Jorgensen rifle’s magazine feed door

Most rifles of the day also had a magazine cut-off, which allowed for manual single-loading of rounds directly into the chamber while leaving the topped off magazine “in reserve” without cycling the bolt. The early Lee-Enfield SMLE and all Springfield 1903 rifles also featured a cut-off.

The Krag’s rear locking system, single-heat treatment (case-hardening), and no spring loaded magazine follower that could cause bolt drag, meant this rifle was restricted to low pressure ammunition, but it is arguably the smoothest military rifle action of them all as a result.

The US government subsequently adopted several updates including the Models 1894, 1896, and 1898. Many of these changes were slight changes to the bayonets, upper handguard, rear sight, and stocks but the essentials of the action remained the same. There were both full-length rifles as well as “Cavalry carbines” issued to our Army. Carbines lacked any provision for mounting bayonets, and there was also a special version for the Philippine Constabulary after the American colonialization of those islands after the Spanish-American War.

Just as the British soldier had encountered substantial problems with both the initial lack of a “charger” loading system (known more commonly here as “stripper clip”) for quick reloads, the use of round-nosed full-metal-jacketed bullets when attempting to stop hostiles, the Krag’s primarily rear locking of its action, and deference for its metallurgy limits its ballistic potential, it was the second-shortest official issue US military rifle in history, only the five years of the M14’s tenure was shorter.

Many more rifles were built than carbines, and are thus less expensive for the burgeoning collector. Approximately 475,000 rifles and carbines were built between 1894 and 1904.

Original G.I. ammunition (“.30 Army”) was called “.30 U.S. Government” commercially, and is very rare, and it has been known as “.30-40 Krag” after the adoption of the .30-06 in 1903.

United States Marines with their Krag-Jorgensen rifles.United States Marines with their Krag-Jorgensen rifles.

Ammunition is still available for the Krag, though I am unaware of any manufacturer but Remington still producing it (limited) as of 2016. Most of this ammunition is still of round-nosed design, albeit in jacketed-soft-point form. The original military loading was a 220gr RNFMJ at just 2,000fps, while nominal velocity for a typical commercial 180gr. JSP loading is approximately 2,200fps, about ten percent under the .303 British round.

The design of the magazine and the open-topped receiver with its bolt handle track makes it very difficult and time-consuming to re-stock an original Krag into a scoped hunting rifle, not that one should actually do this to a collector’s item. Many that have been “sporterized” in the past were turned into single-shots as a result, as the late Frank De Haas described in his book “Bolt-Action Rifles.”

My only experience shooting the Krag was during my Scouting days forty years ago, and I remember it being a nicely-balanced, fast-handling, and relatively light-recoiling rifle capable of hunting deer-sized game at shorter range. They remain so to this day.

This post The U.S. Krag-Jorgensen Rifle appeared first on AmmoLand.com Shooting Sports News .



Source: http://www.ammoland.com/2017/02/u-s-krag-jorgensen-rifle-2/

Report abuse

Comments

Your Comments
Question   Razz  Sad   Evil  Exclaim  Smile  Redface  Biggrin  Surprised  Eek   Confused   Cool  LOL   Mad   Twisted  Rolleyes   Wink  Idea  Arrow  Neutral  Cry   Mr. Green

Top Stories
Recent Stories
 

Featured

 

Top Global

 

Top Alternative

 

Register

Newsletter

Email this story
Email this story

If you really want to ban this commenter, please write down the reason:

If you really want to disable all recommended stories, click on OK button. After that, you will be redirect to your options page.