Profile image
By AmmoLand (Reporter)
Contributor profile | More stories
Story Views

Last Hour:
Last 24 Hours:

Gun Review: Smith & Wesson Model 638 Revolver

Friday, November 17, 2017 9:09
% of readers think this story is Fact. Add your two cents.

By Terril J. Hebert

Smith & Wesson Model 638 RevolverThe ugly duckling that is the 638.

USA -( I admit being a bit of a traditionalist when it comes to concealed-carry revolvers. I like them with slim grips, fixed sights, and exposed hammers. Why? I couldn’t possibly answer that.

But I am a person of changing tastes. Glock pistols have grown on me given how oddly shaped their subsequent imitators have become. In revolvers, the ugly duckling for me must be Smith & Wesson’s shrouded hammer revolvers. And it has grown on me a bit.

Stuck between traditional exposed hammer guns and enclosed “hammerless” designs, shrouded hammer guns were desirable long before Smith & Wesson made it a production reality with their “Bodyguard” revolvers in the late 1950s. These five-shot small-framed 38 Special handguns were later called the Model 38 and 49, depending on an alloy or steel frame, respectively. These guns featured a shroud built up over the hammer that stops it from snagging on the draw or in the pocket, but the hammer is exposed enough to be grasped and cocked for a single-action shot.

Today Smith & Wesson is still producing their shrouded hammer revolvers, the 638 and the 649, the designations changed to signal the use of stainless steel in their construction. While the all-steel 649 is out there, I have been seeing quite a few alloy-framed 638s on the shelves lately, so I went ahead and got one to put through its paces.

Smith & Wesson Model 638The 638 holds five rounds of 38 Special +P ammunition. Loading, unloading, and verifying a loaded gun is easy to do.

The Ugliest Cousin?

In Smith & Wesson’s line up of alloy framed snubbies, the 638 is a bit odd looking compared to the charming and traditional 637 or the classic and popular hammerless 642. I have heard them referred to as “humpback 38s”.

At its heart, the 638 is still a five-shot J-frame revolver that features an all-stainless steel construction, except for the frame itself, which is aluminum. Fully loaded, the 638 clocks in at 15.5 ounces.

The gun comes equipped with a pair of rubber boot grips and the same 1 7/8 inch barrel found on other snubbie revolvers and like the others, it is rated for 38 Special +P ammunition. The sights consist of a basic front ramp and rear notch milled in the top strap of the receiver. It also has the keylock above the cylinder release that is featured on most Smith & Wesson revolvers today.

The real elephant in the room is the hammer assembly, which is a straight knurled bar barely projecting from the top of the gun. It is enclosed on both sides by the aluminum frame.

The primary benefit of selecting the 638 would be the single-action capability as the gun can be fired by cocking the hammer and pulling the trigger or simply by pulling the trigger in double action. You get this while retaining some of the snag-free characteristics of the popular Model 642 and other double-action-only revolvers.

Smith & Wesson Model 638 RevolverA seven-inch group at twenty-five yards using LAX 38 Special ammunition, firing double action. Regardless of load, the 638 stacks them in roughly the same size pattern. Though snubbies are considered to be belly guns, it is nice to know the guns are capable further out.

On The Range Again and Again

The Smith & Wesson 638 brand new out of the box had no perceived wear and no sharp edges. The bead blasted matte finish gives the 638 an utilitarian look. The trigger pull is fairly heavy in double-action with the trigger breaking at just under ten pounds. The single-action trigger pull breaks at just over three.

On the range, I blew through over three hundred rounds through the pistol with most of it consisting of standard pressure loads though a few boxes of +P were also expended.

Loading the 638 is simple by pressing the cylinder release forward and popping the cylinder out to the side. Slide in your loose ammunition and close the cylinder. Easy.

I started by shooting some standard pressure 158 grain LAX full-metal-jacket ammunition on a series of small bullseyes at seven yards. I lined the sights on the target and pulled the trigger. The hammer raised then fell and the gun jolted up in my hand. A stream of light radiated through the center of my target. I kept firing, missing the intended target every other time but stacking the remaining four rounds into a respectable three-inch group. I unloaded the gun by pressing the release again, popping out the cylinder, and thumbing the ejector rod.

These, and the other standard pressure load of choice, Blazer Brass 125 grain FMJ ejected easily in this manner. I also tried Hornady’s Critical Defense 110 grain FTX rounds and the rounds favored a little low, but the group remained the same. Recoil with the standard pressure loads is tame, though the pistol is jumpy in the hand. It wasn’t difficult to get back on target and after extended firing, I felt more heat off the gun than actual pain from recoil.

However, most people today are loading their 38s with +P or higher-pressure ammunition. I opted to try some low-tech varieties, Winchester White Box 125 grain hollow-points and Remington 158 grain lead hollow-points.

Recoil with those loads was more severe. The back of the grip started to jar the web of my shooting hand enough to hurt after about ten rounds of the Remington fodder, but it took about thirty rounds of the Winchester 125s to get the same effect. The +P ammunition may be an issue for the more recoil sensitive or infirm shooters.

The higher pressures involved made the cartridges stick in the chambers and thus required a sharp, smack of the ejector rod to clear the gun. None of this should come as a surprise with very lightweight guns, but what did come as a surprise was the consistent accuracy amongst the different loadings. Firing double action and semi-rapidly, I could get all rounds in a three-inch group with ease, perhaps a shade more, at seven yards.

Things weren’t too difficult at twenty-five yards. Despite that the grips only guarantee a two-fingered grip, I was able to hold steady and post consistent six to seven-inch groups at that distance. All these groups may be improved by firing the gun in single action, but that didn’t help me at all. Thumbing back the hammer on the 638 isn’t as easy as on a standard revolver.

It is mostly hidden, denying your thumb leverage. I found myself relying on the aggressive knurling on the hammer to allow me to drag it back for some single-action shooting. The trigger is light, perhaps too light. In any case, I found myself pulling enough shots to make my single action and double action groups almost identical.

Reliability through the test was one-hundred percent, even when firing the pistol through a coat pocket. Drawing from a coat or jeans pocket was easy and the gun blends in well with a minimal holster investment.

Smith & Wesson Model 638 RevolverA comparison between the 638 (left) and the hammerless 43c (right).

A Few Dings

The one hitch I encountered during testing involved speed reloading. Conventional HKS and Safariland speedloaders became wedged against the grip panel as the loader is pushed into the cylinder. This is not an issue of the gun but the stock factory grips. Instead of changing out the grips for greater clearance, I took off the grips and shimmed down the area of contact with a Dremel.

I found myself wishing the 638 had the same grips as the new “bodyguard” revolver that don’t seem to have that issue. There are also a few small considerations to think about if you choose the 638.

While some might worry about pocket lint getting into the hammer channel, hindering function, this is a remote possibility that is eliminated by attention to detail and a quality pocket holster. What is a valid consideration is the difficulty of de-cocking the gun.

Cocking is a little tough because there isn’t much to grab onto, but if you find yourself with a cocked revolver and it needs to be made safe. I found putting most of my thumb forward of the hammer as I ease it down to work every time without the hand slipping.

Smith & Wesson Model 638 RevolverThe Model 637, essentially the same gun as the 638 but the hammer is completely exposed.

A Good Concealed Carry Option?

Even with those caveats, there isn’t an ill feature that could keep me from recommending the Model 638 for concealed carry. Though I think the grips need some work, they worked great with speed strip loaders and they do provide a good forward purchase on the gun. Recoil with good +P ammunition is just tolerable enough, though a good standard pressure load would be the ticket conductive to good practice with some recoil mitigation.

Though I was unable to take advantage of the gun’s single action capability, I can see it being useful when getting used to the gun right after purchase and practicing for longer-range shots, though it is unlikely to play out in real life. The 638 excels at contact distance and close range and I found the gun easy to work with. I didn’t feel at a particular disadvantage accuracy-wise, even at twenty-five yards.

Though the exposed hammer 637 is still my favorite small revolver, the 638 makes for a far better carry gun while still having a little extra versatility that the hammerless guns don’t have. So with the 638, you can have your cake and eat it too, calories be damned.

Terril Hebert

About Terril Hebert:

Terril Hebert is a firearm writer native to south Louisiana. Under his motto—Guns, Never Politics—he tackles firearm and reloading topics both in print and on his Mark3smle YouTube channel, where he got his start. He has a soft spot for ballistics testing, pocket pistols, and French rifles. When he is not burning ammo, he is indulging his unhealthy wildlife photography obsession or working on his latest novel. Scourge of God was published in 2017.”

This post Gun Review: Smith & Wesson Model 638 Revolver appeared first on Shooting Sports News .


We encourage you to Share our Reports, Analyses, Breaking News and Videos. Simply Click your Favorite Social Media Button and Share.

Report abuse


Your Comments
Question   Razz  Sad   Evil  Exclaim  Smile  Redface  Biggrin  Surprised  Eek   Confused   Cool  LOL   Mad   Twisted  Rolleyes   Wink  Idea  Arrow  Neutral  Cry   Mr. Green

Top Stories
Recent Stories


Top Global

Top Alternative



Email this story
Email this story

If you really want to ban this commenter, please write down the reason:

If you really want to disable all recommended stories, click on OK button. After that, you will be redirect to your options page.