Strange Eerie Sounds Heard Over Queens, New York (Video)
(N.Morgan) In this stunning video capture, Mister UFO presents strange noises out of Queens New York. They sound similar to the ones heard in Russia, the same, eerie, strange, unearthly sounds. These sounds could be residual sounds of HAARP activity, but I cannot say that for fact, only in theory. It could be the frequencies bouncing off of objects or something along those lines.
The HAARP sound recording may seem full of static. It is not. The rushing roaring sound of a blow torch is the HAARP signal itself, as shown by the silence or background noise of the receiver at the end of the pulse, and by the clarity of the tones at the beginning. If you wanted to see or hear the ULF (ultra low frequency) waves sent out by the HAARP transmitter, you will be disappointed here.
My receiver is not equipped to record ULF waves in the region of 1 to 10 Hz, and has an audio roll-off in the range of about 30 Hz. And besides, you can’t hear or see a 0.9 or 1 Hz signal anyway. It is way below the range of normal human hearing. You need instruments to sense it. A powerful 1 Hz sound would probably be “sensed” as a slow rolling earthquake or a slight rocking motion as on the ocean. Nonetheless, a major component and purpose of the HAARP signal is an audio modulation at the frequency of about 0.9 Hz. And what is that purpose? I’ll get to that in a moment.
2. HAARP Interaction with the Atmosphere
The HAARP pulse is primarily divided into two components. The first part is the sections marked A and B on the chart above and is the powerful “pre-heat” megawatt pulse aimed upward at the ionosphere just above the HAARP facility. As the radio waves travel up through the atmosphere they have no effect until they reach the ionosphere about 200 kilometers above the earth, which is far above the atmosphere. At that point the waves interact with the ions, which may be electrons, protons or ionized parts of atoms like oxygen, ozone or nitrogen.
3. Components of the HAARP Pulse
In portion A of the pulse, identifier tones are sent at frequencies of 360, 1000 and 1700 Hz, with some harmonics at higher frequencies visible on the graph. In part B the tones are 650 Hz with a harmonic at 1300 Hz. On the chart the yellow color indicates a very strong signal, the green indicates a medium strength signal and the blue shows a weak signal. In part C of the signal there is a continuous tone at 2100 Hz which remains during the whole pulse and sometimes several seconds afterward. There is also a much weaker tone around 2500 Hz during all of the pulse. And then there is all that green/yellow stuff at the bottom, sloping upward to the right during all of part C. What the heck is that? To explain that we need to look at the HAARP antenna itself.
APeX - Far superior to colloidal silver in destroying viruses, bacteria and other pathogens.
Ultimate Curcumin - Natural pain relief, reducle inflammation and so much more.
Supreme Fulvic - Nature's most important supplement! Vivid Dreams again! See Testimonials
MitoCopper - First bioavailable copper destroys pathogens and gives you more energy.
Prodovite - The Secret To Healing is in the Blood! Complete absorption in 5 minutes.