|
浏览次数 | |
现在: | |
最近一小时: | |
最近24小时: | |
浏览总量: |
The first step to clean up any excess water from the sink. Look at the Bathtub faucet sewer assembly and ejection rod. Using a pair of pliers threaded rod grab lock nut and loosen the lock nut, near the top of the sewer. If the locking nut is loose, there is a little relaxation during assembly and swing, and there will be residual water overflow. Back to the top of the tank and unscrew the pop-up, before removing the ring from the bottom. Can be ready to install a new pop-up.
The second step to install the drain flange of the drainage hole cleaning old or caulking putty. The plumber’s putty flange completely around the bottom of the top of the chrome ring. To the right amount, the most important is to cover the bottom. Some components of the rubber pad or you can also use silicone sealant, but the plumber’s putty work is the most important.
The third step to the bottom of the Waterfall faucet, a pipe joint at the bottom of the putty rubber gasket assembly. This will make sure you get a good seal at the bottom of the sink. Through the bottom of the bottom sink to the rubber pad has a good seal, screw the top flange into the bottom of the assembly, stick from the top of the sink. It doesn’t need to be nervous. The most important thing is that it is connected, and not cross thread, use a wrench or pliers, locking nut tightening assembly on the bottom ring, and between the excess putty will squeeze out the surface subsidence, with a clean cloth wipe.
The fourth step is to install the brake, which is put into the top of the Faucet parts to make sure the back of the tunnel face. Again, back to the bottom. The remaining slug unit consists of a ball and a lever. Ball nut, threaded pipe. Ensure that the unit is moved up and down through the push rod.
Learn more special tips of US faucets learn more faucets information before using, please visit our high quality faucet online store: www.faucetsmarket.com/