Super Joepipe Heater Hybrid DIY Implosion Generator

  Creating over unity heat with implosion-explosion dynamics.

Best test ever since the discovery of the joepipe technology in the summer of 2004.

Test pipe is 1.5 inch clear quartz  x 16 inches with propane and fan air.

     In this test the level 3 flame inside the pipe was increased in mass by 300 percent with once simple trick.  Three feet away we were getting our faces burned by the radiate heat coming off of the quartz pipe.

     Outside flame temperatures under normal conditions has been measured betweem 2,000 to 2050 F on a hot summer day. Exterior flame temps here is estimated in and around 2,250 with internal flame or implosion temps at around 2,450 F. Hot enough to turn the quartz a light orange in the daylight. Quartz is rated at 5, 000 F. Adding a cracked diesel as an secondary fuel should cause the flame to burn white hot.

     By shortening the flame inside of the pipe has been shown in past tests, to increase the resonate frequency thus raising overall temps.  This should bring the white part of the implosion flame aka level 3 flame to the end of the pipe. In this test the white flame take up approximately 50 percent of the interior length of the quartz.

    Coupled with an ultra sonic injector to add dissociated diesel or waste oil should break down to sub micro hydro carbon chains to make the most efficient and simple oil heater par none. Would like to do a u fund me project to make this super hybrid heater. The next step would be to use a second ultra sonic injector to emulsify water. The super heated carbon should pull out the oxygen from the super heated steaming freeing a free hydrogen molecule. As the emulsified diesel vapor exits the joepipe, it should be possible to increase overall efficiency by 300 percent if used as a oil heater.

   With the fires up in Fort Mac it seems that a artificial created shortage is under way. With over 5,000 hours of joepipe testing over a period of 12 years, it should be possible to design a super emulsified system to create a bonding between heated carbon chains and super heated steam that should free the hydrogen in the steam.  The system could be set to pulse in the emulsified water-fuel as a kind of super heat booster with the joepipe itself used as the catylist.

    You may contact me with you questions and comments.

TAGS- Joe pipe, implosion dynamics,  over unity heat, thermal generator, free energy,   stoichiometric heating, stoichiometric heater, vacuum generated heat,

https://youtu.be/rCNeicD3Tuw