Log Cabin Foundation Piers are Complete

Then one fine day, help showed up. She’s not unfamiliar with the project as she has helped fell, skid, and skin logs here. Melonie (Mel of the Mountains) was a welcomed sight as she used her bakery skills to apply mortar between blocks. No waste and greatly sped up the pier building process. She also stacked block at each footer hole, hauled 60 pound bags of cement/mortar, built frames for footers, and backfilled piers with a shovel.

Once a hole is shoveled and leveled somewhat, I then level the footer box, add rebar, mix concrete in the wheelbarrow with a hoe, and pour it smooth. While still wet, I set the first layer of blocks in the concrete. Laying the remaining blocks was a matter of following the bottom pattern. Easy peasy!

My largest piers were constructed with three blocks on the base layer. These large piers will support sill logs and also serve as a solid foundation for the ridge pole support logs (RPSL) down the center of the cabin and the purlin support logs (PSL) on either side of the ridge pole. Both of the RPSL and PSL will stand vertically on these piers to reach their respective roof structural logs.

I also cemented J-hook rebar in several block cells on the building perimeter. Sill logs will be pre-drilled to match the rebar locations. The rebar will be guided through each sill log as it is slowly lowered onto the piers.

Once the log is in place, the rebar will be hammered flush over the top of the log to anchor it to the piers. This first layer of wall logs will take the most time and effort to install. Then the stacking begins!

This coming week I’m going to sort, label, and prep logs for the wall construction.

Thanks for following the journey, and, as always, Keep Doing the Stuff of Self-Reliance.

~ Todd

P.S. – You can also keep up with the Stuff we’re Doing on Flote, Odysee, Pinterest, YouTube, Instagram, and Facebook… and over at our Doing the Stuff Network.

Thanks for Sharing the Stuff!

Copyright © by Survival Sherpa