A General Review of Multi-Fuel Stoves Part3

Take a good look at the stove in the above photo. It has several design features that I would avoid at all costs. Why would I avoid this type of design?  There are two main reasons. Actually, there are more than two reasons I would avoid this type of design, but for this post, I will stick to the main two.

1. Double doors: There is no practical need for two doors in the average size of stove. Two doors are simply a style element, and one which generally causes problems.

Two doors mean a conplex closure, and that there is nearly half as much again of the amount of seal needed and therefore more places for air to leak in. Air leaking into a stove spells trouble and causes problems. It can create hot spots of burn – like a little blow lamp – think of blowing to start a fire. A thin stream of air will cause fuel where it strikes to burn brighter. Air leaking in any crack in the seal between the two doors will create a hot spot of burn and this can lead to damage of the grate or retainer.

Air leaks also means that it is more difficult to control the general burn rate of the fire, this leads to inefficiency or overheating.

The seal between the two doors is right slap in the middle of the fire – the hottest place – it is going to be difficult to maintain a good seal at the best of times – but the roasting heat on the doors is going to cause some expansion of the metal and some warping.

Many double door stoves have only one latching point, in that case, it is next to impossible for there to be a good air seal.

Double doors generally means double air controls – more difficult to control the burn rate – quite simply put – a pain in the ass!!

In the slightly better design of double door stoves above, there is a top and bottom latching system. There still exists in this stove the second major design problem.

2. Sliding air controls: It is next to impossible to get any sort of fine adjustment of the air supply with sliding air controls. The rotary type of air control, if they are of reasonable quality, can give you an almost infinite degree of control of the air supply to the point of cut off. You will never get this with sliding controls.

Additionally, sliding air controls are usually spring loaded and slide areas can become clogged or corroded this leads to the tendency to stick making them very annoying to adjust.